Kool Stop Dura 2 Inserts Carbon

Key Features:

  • Water grooves
  • Reduced weight
  • Rim friendly compounds
  • 7 mm contact ideal for narrow rims
  • Fits 55mm length holders
  • Weight: ca. 11 g/pair
  • Made in the USA

Redesigned the Dura 2 inserts are lighter and thicker than the original Dura inserts. This model does not have a plow tip and it is thicker thus laster for a longer time.  It has a 7.65 mm contact width for narrow rims and cut outs for reduced weight. The Dura 2 pads are the same spec as Shimano pads and fit Shimano, Sram, TRP and Tektro holders with a set screw

This special compound is designed for carbon rims

Installation Instructions:

  1. Clean the rim surface before installing new pads
  2. Place the new Kool Stop pads into the brake caliper arms and finger tighten the nuts
  3. Squeeze brake lever to allow correct pad to rim alignment; tighten the nuts.  Do not over tighten
  4. Break In Pads.  Full stopping power may not develop until after several braking applications have conditioned the rim surface.  Proper "toe in" alignment prevents brake chatter
  5. Check the pad and rim alignment after the pads are broken in and after every ride
  6. Important: Do not ride the bike until the brakes are checked and functioning properly.  Designed for bicycle use only.  All Kool Stop Pads meet or exceed C.P.S.C and D.I.N bicycle standards

Supplied as a pair


MSRP: £14.00


Amba Distribution Limited
Powered by B2B Wave