Kool Stop Thinline Cantilever Salmon

Key Features:

  • Low profile
  • Hardened and plated reinforced steel backbone
  • Patented angled tip plow
  • Water grooves
  • Knurl-lock washer system
  • Self tow in
  • Available in threaded and 2024 Aluminum smooth post
  • Weight: ca. 32 g/pair
  • Length: 72 mm 
  • Pad contact width: 9 mm
  • Made in the USA

The Thinline cantilever pad is longer and thinner than it predecessor and is designed for brake systems with tight brake clearance and for easy tyre removal. It has an easy to remove M6 threaded post with washer and has four spacing adjustments to suit. This pad has a hardened rigid internal backbone that helps pack a lot of performance into a small space

The special Salmon compound is for use in wet and muddy conditions

Installation Instructions:

  1. Clean the rim surface before installing new pads
  2. Place the new Kool Stop pads into the brake caliper arms and finger tighten the nuts
  3. Squeeze brake lever to allow correct pad to rim alignment; tighten the nuts.  Do not over tighten
  4. Break In Pads.  Full stopping power may not develop until after several braking applications have conditioned the rim surface.  Proper "toe in" alignment prevents brake chatter
  5. Check the pad and rim alignment after the pads are broken in and after every ride
  6. Important: Do not ride the bike until the brakes are checked and functioning properly.  Designed for bicycle use only.  All Kool Stop Pads meet or exceed C.P.S.C and D.I.N bicycle standards

Supplied as a pair

MSRP: £12.50


Amba Distribution Limited
Powered by B2B Wave